1 When setting up the connection shown in the graphic, which configuration aspects should be set to obtain a successful ping between PC1 and PC2? (Select three.)
PPP needs to be enabled on the routers.
Each router should declare both networks inside the routing protocol, the one on its AP side as well the one on its LAN side.
Both bridges should belong to the same network.
The network between Bpod1 and R1 should be different than the one between Bpod2 and R2.
SSIDs should be the same on both bridges.
2 Cisco Aironet bridges operate at which layer of the OSI model?
physical
data-link
network
transport
3 Which mode establishes the parent-child relationship between bridges?
Non-Root Bridge
Root Bridge
Access Point Repeater
4 When configuring a Cisco Aironet Bridge through its web browser interface, which methods for IP assignment can be selected in the Boot Server Setup Page? (Select two.)
BOOTP
NVRAM
TFTP
DNS
DHCP
5 Which Radio Port Configuration page contains the MAC address of the Primary Port?
Root Radio Hardware
Root Radio Address
Root Radio Identification
Root Radio Advanced
6 In a large WLAN, how many root bridges can exist?
one
three
five
unlimited
7 When a Cisco Aironet Bridge is configured through the web browser interface, additional routes can be defined in the Routing Setup Page. Which information must be provided for each new route? (Select three.)
DNS server IP address
destination network
wildcard mask
gateway
subnet address
subnet mask
8 Which wireless bridge mode is not covered by 802.11 standards?
access point
non-root bridge
repeater
non-root bridge without clients
9 To utilize hot standby, which parameters need to be configured? (Select three.)
Service Set ID (SSID)
IP address for the monitored access point
MAC address for the monitored access point
Gateway address for the monitored access point
polling frequency
10 Which bridge configurations prevent communication with wireless clients on the LAN? (Select three.)
Access Point
Non-Root Bridge without Clients
Repeater Access Point
Root Bridge
Site Survey Client
11 In order for wireless clients to attach to a non-root bridge, the non-root bridge must be associated to a root bridge or which other type of bridge?
isolated non-root bridge
workgroup bridge
another non-root bridge that is associated to a root bridge
workgroup bridge associated to a root bridge
12 When updating firmware through a distributing access point on a WLAN, which requirements must the access points meet? (Select two.)
The access points must be set to Automatically Update firmware.
The access points must be running firmware that supports the Distribute Firmware feature.
The access points must have their web servers enabled for external firmware updates.
The access points must have their web servers enabled for external browsing.
13 In the graphic, which bridge pairs are able to communicate with each other?
bridge pair A
bridge pair B
bridge pair C
all bridge pairs
14 When using a standby access point for redundancy in a WLAN, which parameter on the standby access point should be different from the monitored access point?
SSID
IP address
default gateway
DNS
15 When setting up two Cisco Aironet 350 bridges for a point-to-point connection, how should the bridges be configured? (Select three.)
System names should be the same for authentication purposes.
Both bridges should belong to the same network.
Both bridges should have the same SSID.
Their roles should be root bridge and non-root bridge without clients.
Their roles should be root bridge in both bridges.
16 Why is bridging one of the most preferred uses of wireless networks? (Select three.)
low equipment costs
rapid deployment
high speed connectivity
more efficient encryption
ease of installation
no geographical limitation on installation
14 hours ago